How to Make an Engine Hoist Out of Wood

An engine hoist is an essential tool for anyone who wants to work on their car engine. It allows you to safely and easily remove the engine from the vehicle so that you can repair or replace it. While you can purchase an engine hoist from a store, it’s also possible to make your own out of wood.

This article will show you how to do just that.

Wooden gantry to lift engines

  • Cut the wood into four equal pieces using a saw
  • Drill two holes in each piece of wood, making sure they line up with each other
  • Run a rope or chain through the holes, and tie it off so that it is secure
  • Attach the engine hoist to the rope or chain
  • Lift the engine hoist into place and secure it to something sturdy so that it doesn’t fall over

Homemade Engine Hoist Plans

If you’re in the market for an engine hoist, you may be considering buying a pre-made model. But did you know that you can save yourself some money by making your own? With a little time and effort, you can build a sturdy engine hoist that will serve you well for years to come.

Here are some tips to get you started: 1. Decide on the size of your hoist. This will depend on the engines that you plan to lift.

A smaller hoist can be made from 2x4s, while a larger one will require 4x4s or 6x6s. 2. Cut the lumber to size according to your plans. Make sure all of the cuts are square so that your finished product is stable.

3. Assemble the frame of your engine hoist using screws or nails. If using nails, predrill holes to avoid splitting the wood. 4. Install pulleys at either end of the frame.

You’ll need two pulleys for each end, plus an additional one for the lifting cable itself. Use heavy-duty pulleys that are rated for loads heavier than your engine’s weight. 5 .

Attach a length of chain or rope to each of the lower pulleys, and thread it through the upper pulley on its corresponding side.

How to Make an Engine Hoist Out of Wood


How Do You Support an Engine Without Hoist?

If you need to support an engine without a hoist, there are a few things you can do. First, if the engine is still in the vehicle, you can use jack stands to support it from underneath. If the engine is out of the vehicle, you can place it on a sturdy table or workbench.

You will also need to block up the front and rear of the engine so that it cannot tip over.

How Much Weight Can an Engine Hoist Hold?

An engine hoist is a tool that is used to lift and move engines. They come in a variety of sizes and can hold different weights. The weight that an engine hoist can hold depends on the size and capacity of the hoist.

Some engine hoists can hold up to 1,000 pounds, while others may only be able to hold 500 pounds. It is important to know the weight limit of your engine hoist before using it so that you do not overload it and cause damage.

What is a Engine Hoist Made Of?

An engine hoist is made of a large frame with a lifting arm attached. The frame is usually made of steel or aluminum, and the lifting arm is typically made of steel. The engine hoist is designed to lift heavy engines out of vehicles so that they can be repaired or replaced.

Engine hoists typically have a capacity of 1,000 pounds (450 kg) or more.

How High Does an Engine Hoist Go?

An engine hoist typically has a lifting capacity of about 1,500 pounds and can reach a height of about 12 feet. The average cost of an engine hoist is around $200.


If you’re looking for a way to make an engine hoist out of wood, then this blog post is for you. The author walks through the process of creating a wooden engine hoist step-by-step, including diagrams to help visual learners. With clear instructions and helpful tips, this post makes it easy to build your own engine hoist out of wood.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *